Wednesday, July 11, 2012

Wet Forging Blowing the Scale Off




 Even though I make my chef knives in an entirely different way than the Japanese do, there is still much to learn from them! I was watching some videos of modern Japanese smiths creating chef knives and saw them near the end of the forging cycle placing some water on the anvil.

I realized that this was nothing new and has been done for centuries, but for me it was a real leap forward in that I forge all of my blades to about 90% of their final geometry and remove the scale by means of a hand stone and water, then draw-file the final geometry. 
Having less scale formulated throughout the forging process is a real bonus. 
I shot this video of myself "Blowing the Scale Off" of a large 10"+ Chef Knife Blade. 
This video represents a beginning for me in presenting information about my approach as a bladesmith specializing in chef knives.

Below the video a shot of the first two blades out of my new furnace which shows some fairly-clean, freshly forged blades, that represent this process of "Blowing the Scale Off" using water on the anvil. And another shot of how I descale by blades...pretty simple and yet effective. 
And finally a comparative shots: the top blade where I used no water on the anvil and progressing down to the bottom blade that came out practically scale-free!

Enjoy!  -DON:)




1 comment:

  1. Good post Don and great looking blades. Controlling scaling and the resulting pitting is so important on thin forged blades and especially when stock reduction is primarily done by hand.

    ReplyDelete